Aphex Channel Bedienungshandbuch Seite 1

THE COMPLETE CHANNEL STRIP FOR VOICE AND INSTRUMENTSCHANNEL™MASTER PREAMP & INPUT PROCESSOROwner’s Manual

Page 10If you want complete silence between phrases, then use the maximum depth. However, if you simply want to bring down ambience pickup as with mul

Page 114.2 SERVICE INFORMATIONIf it becomes necessary to return this unit for repair, you must first contact Aphex Systems, Ltd. for a Return Autho-riz

Page 12OUTPUTConnector:Type:Output Z Balanced: Output Z Unbalanced:Nominal LevelMaximum Output Level (MOL):5.1 GENERAL SPECIFICATIONSXLR-3M and TRS 1/

Page 135.2 ARCHITECTURAL SPECIFICATIONSBASIC DESCRIPTIONA single channel processor comprising microphone and instrument inputs, transformerless tube m

Page 14This product is protected under one or more of the following Aphex patents.4578648, 4633501, 4843626, 4939471, 5115471, 5155769, 5334947, 53596

Page 2CAUTION: For continued protection against risk of fire, replace only with the same type and rating of fuse.ATTENTION: pour une protection continu

Page 3Copyright 2011 by Aphex. All rights reserved. All Aphex products are trademarks or registered trademarks of Aphex. Other brand and prod-uct name

Page 4POWER INDICATIONThe Aphex logo above the power switch glows yellow during the tube preamp’s warm-up time and green when the unit is ready.LOW NO

Page 5WHY YOU SHOULDN’T CONNECT THE CHANNEL’S OUTPUT TO A MIC LEVEL INPUT. The bottom line: you will get an unsatisfactory noise level. The Channe

Page 62.0 INSTALLATION & INTERFACING2.3 MIC INPUT CONNECTIONThe microphone input connector is located on the rear panel. It is the standard XLR-3F

Page 72.5 OUTPUT CONNECTORSThere are two output connectors located on the rear panel: one 1/4” TRS phone type and one XLR-3M type. They can be used at

Page 83.1 USING THE MICROPHONE INPUTThe Channel is perfect for all types of microphones, either powered or not. We encourage you to try every mic you

Page 9Figure 4-2 Phase Cancellation EffectDistance to Mic2Distance to Mic1SoundCancelled=3.5 USING THE PADAn input pad is nothing more than a resistiv