Aphex 5200 Bedienungsanleitung PDF herunterladen (Seite 3)

For the 188 follow these instructions:

Turn the encoder clockwise until you get to a screen that shows SYSTEM CONFIGURE.

In order to safeguard against unwanted changes to the system configuration, the rotary

encoder must be pressed in for several seconds. The system configuration includes

clock source, format and sample rate, display contrast, Net Number assign, DHCP/IP

select and system configure exit.

Net Number

The Net Number identifies the particular unit within a system. Note: There must be only

one unit assigned to one Net Number otherwise the Remote Control and metering will be

unpredictable.

DHCP/FIXED IP

DHCP requires a network router, which will ʻserveʼ an IP address dynamically. Fixed IP

forces the address that is programmed into the unit and modified by the Net Number.

The letter ʻDʼ will be in front of the IP address when DHCP is selected and the letter ʻFʼ

will be in front of the IP address when Fixed IP is selected. For our needs, this MUST be

set to DHCP.

CONNECTIONS

Connect CAT5 patch cables from all preamps to the 100 Base-T network switch (The

switch may not be required if your network router has enough inputs for all of your

preamps). Connect the 100 Base-T network switch to the 100 Base-T network router via

CAT5.

Connect the null modem cable from the Yamaha HA REMOTE output to the RS-422

input on the Aphex 5200. If you connect to a Yamaha PM5D or DM2000 set the [PC RS422]

switch next to the HA REMOTE connection to RS422.

Press the REMOTE WAKEUP on the 5200.

The following Aphex parameters cannot be adjusted from Yamaha digital mixers:

1. Pad on/off

2. Phase reverse on/off

3. MicLim on/off

4. Mute on/off

For DM1000 users:

The DM1000 can control the gain and phantom power settings on each channel of the 1788A and

188 when used with an Aphex 5200 LAN interface. The DM1000 can control up to four preamps

simultaneously.

Tip: You cannot store the Phantom power setting as a Scene on the DM1000. This section

describes how to connect and configure the DM1000 and two preamps.

Make sure the proper digital I/O cards are installed in the DM1000.

Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup Remote page appears.

(See image below)

1 2 3 4 5 6 7 8 ... 14 15

Keine Kommentare

Aphex 5200 Bedienungsanleitung Seite 3